1/22/2024 0 Comments Samba vw ghiaGood luck and remember to have fun! Seat covers and door panels are also TMI. openings carefully, you only get one chance. Also work your way into the center, some of it will make more sense as you start to lay it out. My advice would be to start high so the glue won't drip onto any new carpet you already put down. TMI kit, which fit quite well in my opinion. Just finished my carpet install on Monday. Posted: Fri 6:46 pm Post subject: Carpet install Life is hard and its harder if you're stupid. I build a custom console that will cover that area so I may just cut a lengthy slit and trim it to fit prior to gluing it down. As for the tunnel piece I haven't thought it out yet. The vents are opened and closed with the heat/defrost lever. Those pieces are trimmed to fit around the heater vent opening and I plan on gluing them down. The carpet pieces that run along the floor vents (#12 and #13) are not edged and have no rubber piece either. My kit is a TMI kit with no rubber on thr driver's side floor carpet by the gas pedal. My kit would need the holes cut in the rocker pieces. I have made a template with craft paper, but that is as far as I have gotten.Ģ. Have you given any thought to how to mark the shifter and emergency brake. In fact, I have 1-8 (except 7) installed. Thanks for the the proposed install order. You can figure most of it out by the edge banding, but it would save a lot of time.Īlthough I have a coupe, this is the order that I plan on installing mine in and would suggest for your. It would be nice to have a simply diagram with a recommended install order. My only complaint (as others have stated) is there are NO instructions. They asked me to return the carpet and they sent me a TMI kit. Which makes it even funnier that they could not figure out where that piece goes.Īfter several conversations with Mid-America. Not TMI, It was Mid-America's inhouse brand. I'm interested to know if that was a TMI kit you got, since I'm anxiously awaiting delivery of mine. Pat, I laid out all the old felt 'carpet' pieces from my '71 and couldn't find a match for that piece either. I called the company that sold it to me and they couldn't figure it out either, so they are sending another set from a different vendor. Anyone have an idea on this carpet piece? I found that a small handheld steamer (like one you would use to get the wrinkles out of curtains) came in very handy when trying to make the compound curves with a flat piece of carpet. It seems that the tunnel and rocker covers should be installed first and build out from there.Īs always, any help would be appreciated?Īll of the side pieces and the center tunnel carpet go in first, then the floor carpet goes in last to cover the edges. Is this for the driver or passenger side? How high up goes it go?Īlso can anyone recommend an install order for the main area. However, I can't determine how to place/install it. I believe that this piece goes against the side in the rear (behind back seat) of my 71 vert. I bought an inexpensive carpet kit and of course no instructions not even a packing slip.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |